6F8C1048 87
Chapter 7 Installation
and Wiring
Fully read this manual and the Process LAN ADMAP Installation and Wiring Manual
(6F8C0479) before starting installation and wiring.
Warning
• For safety, be sure to check that the base unit has been switched off before starting installa-
tion or wiring AN712 modules.
• For safety, do not touch the insides of the product except for the switches.
Caution
• Make sure that the environment where the product is installed satisfies the product specifica-
tions.
• Ground the ADMAP-5M, transmission line by transmission line, by class D grounding. (One
point grounding)
• The static charged in the human body may cause the product to fail. Discharge the static
from the human body before starting installation or wiring.
• If the cables are subjected to stress by touching, for example, it may cause malfunction or
accidents. Be careful not to accidentally touch the cables.
• When mounting the product into the base unit, be careful not to break or bend the pins of the
station bus connectors.
• Use a Phillips screwdriver, which fits the screws. This is important to prevent damage to the
screws.
• Verify transmission at the application level using the transmission protocol.
• If power cannot be switched on or if other kind of trouble occurs, stop use and contact the
Toshiba service office concerned.
• If you have any question, contact the Toshiba service office concerned.
To Next Page
Loading...
