6F8C1048 5
Chapter 3 Settings
Warning
• For safety, be sure to check that the base unit has been switched off before installing AN712
modules in it or removing them from it.
• For safety, do not touch the insides of the product.
• For safety, do not disassemble the product.
Caution
• The static charged in the human body may cause the product to fail. Discharge the static
from the human body before setting the switches.
• In setting the switches, do not change other than the necessary settings. The wrong setting
will prevent the product from normal operation.
• Be sure to set station addresses.
Check that the stations of your system are not of the same address.
• If you have any question, contact the Toshiba service office concerned.
To Next Page
Loading...
