88 model 3000 ADMAP-5M AN712 Module User’s Manual
Chapter 7 Installation and Wiring
7
7.1 Installation (Installing in the Base Unit)
To install a module, insert it into the base unit along the module guide from the bottom of
the module as shown in figure 7-1. When it is in the base unit, fasten it with the screws
(M4) on top and bottom of the module.
AN712 module mounting slots
• 8-slot base unit: Slot Nos. S2 to S7
• 6-slot base unit: Slot Nos. S2 to S5
• 4-slot base unit: Slot Nos. S2 to S3
Figure 7-1 Mounting Module in Base Unit
Caution
• Place the base unit vertically, and use a special fan for forced air cooling.
Working temperature range is as follows:
0 to 50
o
C
• Clamp the ferrite core to the AC power cord of the power unit.
AN712 module
Base unit
module guide
Base unit
To Next Page
Loading...
