Toshiba BA400 Series - Auto Print (Trans.); Auto Print (Refl.)

98
8.6.8 AUTO PRINT (TRANS.)
The factory test print is performed on the following conditions, therefore, the parameter settings and the print
density fine adjustment value are ignored.
Key functions after printing of each test pattern are as follows.
[PAUSE] key (or its substitute key): Next printing is performed.
<Factory test print patterns and print conditions>
Print test pattern
1 blank label
3-dot slant lines
Barcode
Characters
Issue count
5 labels each
Print speed
203 dpi
4 ips
300 dpi
4 ips
Sensor type
Transmissive sensor
Print method
Thermal transfer
Issue mode
Batch issue
Label pitch
76 mm
Print density fine adjustment value
±0
8.6.9 AUTO PRINT (REFL.)
The factory test print is performed on the following conditions. therefore, the parameter settings and the print
density fine adjustment value are ignored.
Key functions after printing of each test pattern are as follows.
[PAUSE] key (or its substitute key): Next printing is performed.
<Factory test print patterns and print conditions>
Print test pattern
1 blank label
3-dot slant lines
Barcode
Characters
Issue count
5 labels each
Print speed
203 dpi
4 ips
300 dpi
4 ips
Sensor type
Reflective sensor
Print method
Thermal transfer
Issue mode
Batch issue
Label pitch
76 mm
Print density fine adjustment value
±0