Toshiba BA400 Series - Move to Tearoff; Fw;Bk Act; Pre Peel off

74
8.5.3 MOVE TO TEAROFF
OFF Disables the auto feed to the cut/strip position after printing.
ON Enables the auto feed to the cut/strip position after printing.
* Thermal transfer with 2 ips with automatic forward standby ON operates at 3 ips.
8.5.3.1 MOVE TO TEAROFF POS.
When the "MOVE TO TEAROFF” parameter is set to ON, the feed amount can be fine adjusted.
Max.
value
Min. value
Step
Display
Sign
Integer
digit
Decimal
place
0-padding
Unit of
measure
+5.0
-5.0
0.1
Decimal
Exist
1
1
None
mm
Note: Feed amount setting
+ (Plus) Increases the forward feed amount.
- (Minus) Decreases the forward feed amount.
Notes:
1. If the pitch of the media used for the previous issue was less than 20mm, the auto feed to the cut/strip
position after printing will not be activated regardless of the parameter setting.
* In the case labels with the different pitch (less than 20mm and 20mm or longer) are alternately placed in
one label roll, the forward feed is not activated for the labels with the pitch of less than 20mm. Therefore it
stays at the print stop position without being fed backward. Before the next label with the pitch of 20mm or
larger is printed, however, it is automatically fed backward along with the previously printed label. This
may cause the print data to be printed on the previous label.
2. The media will stay at the forwarded position even if the power is turned off/on, the printer is reset, or the
print head is opened/closed.
8.5.4 FW/BK ACT.
MODE1: Normal: The printer waits for a next issue after media is forwarded 16.7-mm.
MODE2: Reserve: If selected, it will be the same as MODE1.
8.5.5 PRE PEEL OFF
OFF Disables pre peel off.
ON Enables pre peel off.
Notes:
1. The pre peel off speed is the 2ips.