Toshiba BA400 Series - User System Mode; 9.1 Outline of User System Mode; 9.2 Exit

139
9 USER SYSTEM MODE
9.1 OUTLINE OF USER SYSTEM MODE
1. The printer enters the user system mode with the following operations.
 While the printer is in pause state, perform either of the following operations:
Hold down the [RESTART] key for 3 sec. or more.
2. The user system mode is intended for performing various parameter settings.
3. The key operations for the user system mode are described below.
For the key functions and display, see Section 7. DISPLAY PATTERN AND KEY OPERATION FOR
SYSTEM MODE AND USER SYSTEM MODE.
Top screen of user system mode
Display
USER SYSTEM MODE C1.6
▲
<2>SET PARAMETERS
<4>SYSTEM TOOLS
▼
<1>EXIT
<3>DETECTION LEVEL
Top menu list
English
<1>EXIT
<2>SET PARAMETERS
<3>DETECTION LEVEL
<4>SYSTEM TOOLS
<5>ISSUE CONTROL
<6>SHOW ISSUE COND
<7>RESET
Outline of the top menu
<1>EXIT
Used to return the printer to online state. (The printer is not reset.)
<2>SET PARAMETERS
Used to set the parameters for each printer function.
<3>DETECTION LEVEL
Used to set the thershold value.
<4>SYSTEM TOOLS
Used to print data sent from the host or store it in USB memory.
<5>ISSUE CONTROL
Used to set the issue control items (sensor type, print speed, print direction,
etc.).
<6>SHOW ISSUE COND
Used to display the print conditions (such as sensor type, print speed and
orientation).
<7>RESET
Used to reset the printer.
9.2 EXIT
The printer state is returned from the user system mode to the online mode. (No reset is performed.)
Some parameter settings are reset when the Exit is performed. The parameters to be reset are indicated with
“Reset Req.” Other parameters do not reset with EXIT and return to online mode. Also, when transitioning from the error
occurrence screen to the user mode, the screen returns to the error screen before transition.
* If an RFID write error occurs in Z Mode and a transition is made to user mode, the reset is performed in the same way.
Contents of EXIT menu
Menu item
<1>EXIT