Toshiba BA400 Series - System Mode; 8.1 Outline of the System Mode

40
8 SYSTEM MODE
8.1 OUTLINE OF THE SYSTEM MODE
1. The printer enters the system mode with the following operations.
 While the printer power is off, perform either of the following operations:
Turn on the printer while holding down the [FEED] and [PAUSE] key at the same time.
When the following display appears, you can enter system mode by releasing your hands from the [FEED]
key and [PAUSE] key.
2. The system mode is intended for performing self-test and various parameter settings.
3. When the top menu is displayed, the main firmware version is shown on the right side of the title.
4. The language displayed on the LCD is Japanese when “Japanese” is selected for the LCD language
parameter, and English when a language other than “Japanese” is selected. (See <13>LCD PANEL.)
5. The key operations for the system mode are described below.
For the key functions and the display configuration, refer to Section 7. DISPLAY PATTERN AND KEY
OPERATION FOR SYSTEM MODE AND USER SYSTEM MODE.
Top menu of the system mode
Display
SYSTEM MODE C1.6
▲
<1>DIAGNOSTIC
<3>TEST PRINT
▼
<0>RESET
<2>SET PARAMETERS
Top menu list
English
<0>RESET
<1>DIAGNOSTIC
<2>SET PARAMETERS
<3>TEST PRINT
<4>SENSOR
<5>RAM CLEAR
<6>INTERFACE
<7>RFID
<8>RTC
<9>USB MEMORY
<10>FOR FACTORY
<11>BASIC
<12>XML
<13>LCD PANEL
<14>PASSWORD
BA400 Series
Initializing...
entering SYSTEM MODE