Toshiba BA400 Series - Initial Setting

109
Ribbon
(Note)
RBN
Direction
BOTTOM
Media pitch
(Note)
203 dpi: 76.0mm
300 dpi: 76.0mm
Print length
203 dpi: 74.1mm
300 dpi: 74.2mm
Print width
203 dpi: 104.0mm
300 dpi: 105.7mm
Media width
Not cleared
Note: Though the setting value is reset to the initial value by a parameter clear, the first online operation
after a parameter clear is performed based on the value set with the initial setting wizard.
8.8.4 INITIAL SETTING
When Printer do RAM Clear(except JA), printer will show initial setting wizard. In this wizard, you can make
various printer settings such as LCD language and printing method that are required for initial setup. The
contents set in this wizard can be changed by system mode or command transmission.
Wizard operation example after clearing parameters
（RAM Clear QM Type）
1．After Parameter Clear
QM TYPE
CLEAR...
↓
QM TYPE
COMPLETED
Turn off the printer
↓ Turn OFF/ON
BA400 Series
Initializing...
↓
2 ． Show Initial Setting
wizard
STARTUP SETTINGS
PRESS [PAUSE]
↓ [PAUSE]
3．Language Setting
LANGUAGE ENGLISH
▲
ENGLISH
GERMAN
FRENCH
▼
[F]/[R]Select [P]Set
Selected by [FEED]、[RESTART]