20
6.7 RFID Analyze Mode
6.7.1 Outline of the RFID Calibration
RFID Analyze is a function to automatically determine the distance to the optimum write/read position and
the AGC value by RFID Analyze Tool.
LCD will show “RFID ANALZE MODE” when printer is entered RFID Analyze Mode by RFID Analyze Tool.
RFID Analyze Mode is below behavior.
1. Printer will calibrate by using Feed adjust value which set from RFID analyze Tool.
(Printer will not use Feed Adjust value in System Mode.)
2. The HOLD motor is not released after the LF motor stops, and the current (HOLD current) continues to
flow through the LF motor at a predetermined current value.
3. RFID Analyze Mode will be off by Rest or Turning ON
4. RFID Analyze Mode will be off by error.
6.7.2 RFID Calibration Operation Example
To Next Page
Loading...
