120
The number of tag being read/The total number of tags read
(Mostly, only 1 tag is read.)
For the UHF module, AGC value of the read tag is displayed with decimal number.
Data displayed on the 3rd and 4th lines are expressed with hex. code. (16 digits x 2 lines = 32 digits)
The EPC code for the EPC area is displayed.
In the case of 16 bytes or more data, only the first 16 bytes are displayed. When data is less than16 bytes,
the vacant digits will be filled with spaces.
If more than one tag is read at one time, especially when short-pitch tags are used, pressing the [FEED]
or [RESTART] key shows the other tags’ data.
8.10.2 MODULE
The information related to the module setting is displayed.
The menu structure of MODLE
8.10.2.1 MODULE TYPE
NONE No RFID module is installed.
UHF band (U4) BA704- RFID-U4-S (Japan)
BA704- RFID-U4-KR-S (Korea)
BA704- RFID-U4-EU-S (Europe)
BA704- RFID-U4-AU-S (Australia)
preinstall model (BA410T-TS16-CN-S) (Chine)
Note: This setting will become effective after the printer power is turned off, and back to on.
8.10.2.2 COUNTRY
When the module type is set to “U4”, the country code of the currently installed module is displayed.
If the module type is set to other than “U4”, “INVALID” is displayed.
It is possible to change the country setting only when the module type is set to “U4” and the actually installed
module is US or EU or AU. However, this menu is password-protected because changing the country setting
causes the output frequency to change.
To Next Page
Loading...
