Toshiba BA400 Series - Page 80

75
8.5.5.1. PRE PEEL OFF POS
Fine adjustment position setting when “Yes / ON (with pre-peeling operation)” is specified in “Pre-peeling
treatment / PRE PEEL OFF”.
Max.
value
Min. value
Step
Display
Sign
Integer
digit
Decimal
place
0-padding
Unit of
measure
+9.9
-2.5
0.1
Decimal
Exist
1
1
None
mm
Display
Procedure
1. Select parameter settings
<2>SET PARAMETERS
FW/BK ACT. MODE1
PRE PEEL OFF ON
BACK FEED SPEED STD
▼
AUTO HEAD CHK OFF
Move the cursor with [FEED] or [RESTART].
Press [FEED] + [RESTART] to move to the
“Set Parameters” screen.
Press the [PAUSE] key. ↓
2. Select pre-stripping
settings
PRE PEEL OFF
OFF
ON
▼
Move the cursor with [FEED] or [RESTART].
Press [FEED] + [RESTART] to move to the
“Set Parameters” screen.
Press the [PAUSE] key. ↓
3. Select pre-peeling fine
adjustment
PRE PEEL OFF POS.
+1.0mm
( -2.5 - +9.9 ) mm
Pre-peeling fine adjustment can be set to
"-2.5mm-+ 9.9mm".
Press [FEED] + [RESTART] to move to the
“Pre-Peel Off” screen.
Press the [PAUSE] key. ↓
4. Test mode operation
selection
PRE PEEL OFF POS.
TEST or SET
[F] TEST [P]SET
Press [RESTART] to move to the “Pre-Peel
Off” screen.
Press [PAUSE] to move to the “Set
Parameters” screen.
Press the [FEED] key. ↓
Feeds only the distance obtained by adding
the fine adjustment value set from the
pre-peeling distance (6.0 mm).
5. After test mode operation
PRE PEEL OFF POS.
ADJUST or SET
[R]ADJUST [P]SET
Move back to “Pre-peeling fine adjustment
setting screen” after back-feeding the distance
fed in the test mode with [RESTART].
The screen does not move when [FEED] is
pressed.
Press the [PAUSE] key. ↓
Move back to the “Set
Parameters” screen after
back feeding the distance fed
in the test mode.
(Supplement)
 The print stop position at the time of peeling issuance is stopped so that the distance from the center of the
gap between labels to the tip of the peeling table is 4.0 mm. Assuming a gap between labels of 2.0mm, the
pre-peeling distance is 6.0mm by default. This is because 1.0 to 2.0 mm of the distance sent forward from
the peeling table by the pre-peeling operation is significant.