Toshiba BA400 Series - Page 110

105
BACK FEED SPEED
Reverse feed speed
STD
CALIBRATION
(Note)
Auto calibration
OFF
CODE PAGE
Character code selection
PC-850
Character “0” selection
0 (without slash)
CTRL CODE
Control code type
AUTO
PEEL OFF STATUS
Whether to send a peel-off wait status to
the host
OFF
USB I/F STATUS
Whether to return a response to the host
via USB
OFF
FEED KEY
[FEED] key function
FEED
KANJI CODE
Kanji code type
TYPE1: Windows
EURO CODE
EURO code setting
B0 (0xb0)
AUTO HEAD CHK
Auto print head check
OFF
WEB PRINTER
Web printer
function
QM TYPE
CN TYPE
ON
JA TYPE
OFF
RIBBON NEAR END
Ribbon near end detection
OFF
EX. I/O MODE
Expansion I/O operating mode
TTEC Standard
PAPER/RBN END
Printer behavior at label/ribbon end
Stop immediately
MAXICODE SPEC.
MaxiCode specification
TYPE1: Compatible
XML
XML data type to be printed
STD
ENERGY TYPE (T)
Energy level applied to the print head in
thermal transfer mode
NORM: Normal
ENERGY TYPE (D)
Energy level applied to the print head in
thermal direct mode
NORM: Normal
POWER SAVE TIME
Length of time until the printer enters
sleep mode
15min
RIBBON TORQUE
Ribbon torque
Normal
BASIC
BASIC interpreter setting
OFF
BASIC TRACE
BASIC interpreter trace setting
OFF
CUT MODE
Cut Mode setting
TYPE1
MULTI LABEL
Multi Label setting
OFF
FEED LENGTH
Label length warning setting
3200km
TOTAL LENGTH
Total label length warning setting
3200km
PEEL OFF TRQ
Peel off Torque Setting
R0
KB I/F
Keyboard Interface setting
OFF
ISSUE CTRL
Issuance control setting
SENSOR
Sensor
COMMAND
MODE
Mode
COMMAND
SPEED
Print speed
COMMAND
RIBBON
Ribbon
COMMAND
ROTATION
Print direction
COMMAND
STATUS
Automatic status response
COMMAND
Note: Though the setting value is reset to the initial value by clearing a parameter, the first online operation
after clearing a parameter is based on the value set with the initial setting wizard.