Toshiba BA400 Series - Page 132

127
8.10.4.7 ENCODE POSITION
By performing an RFID calibration, an optimum data read/write position (distance from the home position) is
automatically obtained and set.
Max.
value
Min. value
Step
Display
Sign
Integer
digit
Decimal
place
0-padding
Unit of
measure
+999.9
-999.9
0.1
Decimal
None
3
1
None
mm
Notes:
1. This parameter is effective only when the CALIB. MODE parameter is set to ON.
2. The printer will automatically feed RFID media forward/backward for the distance specified by CALIB.
POSITION parameter before writing/reading RFID tag, which is normally performed with @003 command.
3. The feed direction is indicated by “+” (backward) and ““ (forward).
4. Setting values ranging from -2.9mm to +2.9mm do not reflect the read/write position fine adjustment.
5. For details of the RFID calibration, refer to Section 6.7 RFID Analyze Mode.