ON: Connecting to an access point
Bluetooth Connection Icon
Displayed Bluetooth connection status
Displayed Bluetooth Auto Re-conncetion Mode
OFF: Printer is not Bluetooth Auto Re-conncetion Mode
: ON : Bluetooth Auto Re-conncetion Mode
Appears when a print job is present.
ON: Print job is present.
Displayed and used when the RFID module is installed.
Appears when the RFID module type has been set and a
communication between the printer and the RFID module is enabled.
Flashes while communications and operating sequence are made
with the RFID module.
- The communications without radio wave output are included.
- After radio wave output is instructed to the module, this icon flashes even
when there is no radio wave output.
(Flashes while the module stops outputting radio wave under the influence
of other carriers or while changing the channel.)
ON: Module type has been set and the printer is ready to
communicate with the RFID module.
Ribbon near end is detected.
Flashes when the ribbon is close to the end.
Ribbon near end is detected depending on the diameter of unused
ribbon. 38 mm is equivalent to 30-meter ribbon and 43 mm is equivalent
to 70-meter ribbon.
Flashing: Ribbon near end state (*1)
(*1) The icon flashes at a 1-second interval (ON: 500 msec. OFF: 500 msec.)
To Next Page
Loading...
