Toshiba e-studio 16 - Temporary Security TX Change; Security TX (Transmission) Setting

4-27
4
1
Display the SECURITY TX Menu.
Press:
then
Security TX (Transmission) Setting
This function allows transmissions only when the number you dial matches the number programmed in
the remote facsimile. If the numbers do not match, Security TX prevents your facsimile from sending by
indicating a transmission error.
2
Select the Security TX option.
• To select Security TX OFF, press .
• To select Security TX ON, press
.
2
Place the original.
• For details on how to place the originals on the glass.
(
See page 2-8.)
3
Set the scanning conditions. ( See pages 2-10 to
2-15.)
4
Press the key to display the COMM. OPTIONS.
5
To select “1. SECURITY TX,” press .
6
Select the Security TX option.
• To select Security TX OFF, press .
• To select Security TX ON, press
.
This function allows you to change the Security TX selection for a single transmission.
SECURITY TX
1.OFF
2.ON
SECURITY TX
1.OFF
2.ON
1.SECURITY TX :OFF
2.ECM :ON
3.LONG ORIGINAL :OFF
4.LINE MONITOR :OFF
SECURITY TX
09.SECURITY TX
10.COVER SHEET
11.RECOVERY TRANSMIT
7
Specify the remote FAX. ( See pages 2-16 to
2-21.)
1
Press the key.
Temporary Security TX Change