Toshiba e-studio 16 - Setting the Scanning Conditions for each Page; Setting Scanning Conditions for each Page

2
2-14
BASIC OPERATION
When you want to send multi-page originals by using the original glass, you can change the following
scanning conditions for each page:
• Resolution
• Image Mode
• Image Density
• Original size
Tip
When originals are placed on the original feed tray of the optional ADF or RADF, you cannot change
the scanning conditions for each page.
• Set the scanning conditions for the first sheet before you press the
key.
6. SETTING THE SCANNING CONDITIONS FOR EACH PAGE
2
Place the original on the glass.
Setting Scanning Conditions for Each Page
1
Press the key.
3
Set the scanning conditions.
4
Specify the remote FAX.
• Abbreviated Dialing ...... See page 2-18.
• Alphabet Dialing ...........
See page 2-19.
• Group Dialing ...............
See page 2-20.
• One Touch Dialing ........
See page 2-21.
e-STUDIO16 Go to step 5.
e-STUDIO20/25 Go to step 6.
5
Select the original size.
• Using the or key, select the original size and
press the
key.
Select original size
LT
LD
LT-R
SCANNING TO MEMORY
JOB NUMBER :XXX
SCANNING PAGE :YYY
RESIDUAL MEMORY :ZZZ%
BUILD FAX JOB
1.SCAN NEXT ORIGINAL
2.CHANGE CURRENT SETTING
3.COMPLETE
After scanning