4 Replacement Procedures 4.15 LCD assembly/Base assembly
4-50 [CONFIDENTIAL] QOSMIO G50 Maintenance Manual (960-683)
Installing the LCD assembly/Base assembly
The following describes the procedure for installing the LCD assembly/base assembly (See
Figure 4-31 and 4-32).
1. Set the LCD assembly to the base assembly while inserting the right hinge to the
hole of the base assembly.
2. Connect the GPS cable or Wireless USB cable to the connector on the GPS or
Wireless USB.
3. Connect the LCD cables to the connector CN5310 and CN5311 on the system board.
4. Arrange the GPS cable or Wireless USB cable and LCD cables under the guides.
5. Connect the wireless LAN antenna cables to the connector on the wireless LAN
card.
6. Arrange the wireless LAN antenna cables under the guides.
7. Secure the LCD assembly and base assembly with the following screws.
• M2.5×6B FLAT HEAD screw ×3
Downloaded from LpManual.com Manuals
To Next Page
Loading...
Need help?
General