4.23 RTC battery 4 Replacement Procedures
QOSMIO G50 Maintenance Manual (960-683) [CONFIDENTIAL] 4-67
Installing the RTC battery
The following describes the procedure for installing the RTC battery (See Figure 4-41).
1. Set the RTC battery into the RTC battery insulator and install them to the slot of
the base assembly.
2. Connect the RTC battery cable to the connector CN4642 on the USB/Jack board.
3. Arrange the RTC battery cable in place.
Downloaded from LpManual.com Manuals
To Next Page
Loading...
Need help?
General