32RCA001TS-02ISEN
12
RBP-RC001-E Installation & Owner's Manual
How to Install
CAUTION
• Do not wire communication lines or input/output wiring next to power supply wiring, etc, or house them in the same metal
pipe. Doing so may result in failure.
• Install the group remote controller away from the noise sources.
The thickness of the board or wall must be 1.6 mm to 10 mm.
• Prepare the holes for installation beforehand, following the the diagram below (Panel cut dimensions diagram).
• Remove 1 panel fixing screw and open the panel.
• Attach the lower case with the four included fixing screws.
• Close the panel and attach it with 1 panel fixing screw.
< Panel cut dimensions diagram >
Screw holes (4 places)
W:95 × H:84
Square hole
Fixing screw
Panel
Control board or a wall
Panel fixing screw
Lower case
To Next Page
Loading...
