Toshiba RBP-RC001-E - Language Setting; DN Code Setting

32RCA001TS-02ISEN
41
RBP-RC001-E Installation & Owner's Manual
Language Setting
DN code setting
Refer to P. 51 for a DN code list.
[CAUTION]
During running, you cannot change a DN code that requires a restart.
1 On the setting screen, select “Language Setting” and
press [●] (Confirm).
2 Use [Λ] and [V] to select a language.
3 To confirm the changes, press [ ] (Return) and on the
message screen, press [●] (Confirm).
1 On the setting screen, select “DN code setting” and
press [●] (Confirm).
2 Use [Λ], [V], [<], and [>] to select the DN code to set and
press [●] (Confirm).
3 Use [Λ] and [V] to change the value and press
[●] (Confirm).
4 To confirm the changes, press [ ] (Return) and on the
message screen, press [●] (Confirm).
If you changed an item for which appears in the Set column, GR will restart
automatically when the setting change is confirmed.