32RCA001TS-02ISEN
16
RBP-RC001-E Installation & Owner's Manual
Names and Functions of Parts
Operation panel
No. Name Description (Note 1)
1 LCD
2 Operation lamp
ON during running and OFF during stoppage.
You can change the output method by setting “Level of operating output”. (Note 2)
3 Failure lamp
Lights up when a failure occurs.
You can change the output method by setting “Level of failure output”. (Note 2)
4 [ON] button
Press this button to run the GR.
Enabled if GR is set to Unit or External (Run/Stop input not set).
5 [OFF] button
Press this button to stop the GR.
If the GR is set to External and Run/Stop input is set, it is switched to unit stop.
6
[ ] (Control) button
Press this button to display the GR operation screen and the system operation
screen.
7 [Λ], [V], [<] and [>] buttons Press these buttons to select an item.
8 [●] (Confirm) button
Press this button to switch the screen in the order of
All→System→MC→UC→Circuit and to select an item and go to the next screen.
9
[ ] (Return) button
Press this button to return to the previous screen.
10 [ ] (Menu) button Press this button to display the Menu screen.
Note 1: If the backlight is OFF although the backlight setting is not “OFF”, press any button to turn ON the backlight. (For a
button that is set to be long pressed, the backlight is turned ON after it is long pressed.) Button operations are enabled
after the backlight is turned ON.
Note 2: For details, refer to “DN code setting (P. 41)”.
To Next Page
Loading...
