Toshiba RBP-RC001-E - Page 33

32RCA001TS-02ISEN
33
RBP-RC001-E Installation & Owner's Manual
Sensor setting
You can set the system for a control sensor.
Interlock Output Set
Set the output method for the output functions “pattern interlock output1 and pattern interlock output2”.
1 Use [<] and [>] to select “Sensor setting” and press
[●] (Confirm).
2 Use [Λ], [V], [<], and [>] to select the item to change and
press [●] (Confirm).
< and > are displayed, enclosing the selected item.
3 Use [<] and [>] to select a system and press
[] (Return).
4 To confirm the changes, press [ ] (Return) and on the
message screen, press [●] (Confirm).
1 Use [<] and [>] to select “Interlock Output Set” and
press [●] (Confirm).
2 Use [<] and [>] to select the item to change and press
[●] (Confirm).
It is switched between ON and OFF.
3 To confirm the changes, press [ ] (Return) and on the
message screen, press [●] (Confirm).