E6581595
D-10
4
4.3.2 Return to default settings
: Default setting
Function
It is possible to return groups of parameters to their defaults, clear run times, and record/recall set
parameters.
[Parameter setting]
Title Function Adjustment range Default setting
Default setting
0: -
1: 50Hz default setting
2: 60Hz default setting
3: Default setting 1 (Initialization)
4: Trip record clear
5: Cumulative operation time clear
6: Initialization of type information
7: Save user setting parameters
8. Load user setting parameters
9. Cumulative fan operation time
record clears
10 to 12: -
13: Default setting 2 (complete
initialization)
0
This function will be displayed as 0 during reading on the right. This previous setting is displayed on the left.
Example:
cannot be set during the inverter operating. Always stop the inverter first and then program.
Programmed value
50 Hz default setting (=)
Setting to sets the following parameters for base frequency 50 Hz use.
(The setting values of other parameters are not changed.)
Max. frequency () ：50Hz Upper limit frequency () ：50Hz
Base frequency 1 () ：50Hz Base frequency 2 () ：50Hz
VI input point 2 frequency () ：50Hz Motor rated RPM () ：1410 min
-1
60 Hz default setting (=)
Setting to sets the following parameters for base frequency 60 Hz use.
(The setting values of other parameters are not changed.)
Max. frequency () ：60Hz Upper limit frequency () ：60Hz
Base frequency 1 () ：60Hz Base frequency 2 () ：60Hz
VI input point 2 frequency () ：60Hz Motor rated RPM () ：1710 min
-1
To Next Page
Loading...
