Toshiba TOSVERT VF-nC3 User Manual

E6581595
E-3
5
 How to use the guidance function
Here are the steps to follow to set parameters, using the guidance function. (When the basic setting guidance
(auf) is set to 1)
Operation panel
action
LED display Operation

Displays the output frequency (operation stopped).
(When standard monitor display selection = [Output frequency])

The first basic parameter "History ()" is displayed.

Turn the setting dial to select the guidance function ().

Press the center of the setting dial to display .

Turn the setting dial to change to the purpose-specific guidance
setting value "".

Press the center of the setting dial to display the purpose-specific
guidance parameter group (refer to table below).
＊＊＊＊
After moving to the purpose-specific guidance parameter group, use
the setting dial to change the parameters.

 is dialyzed on completion of the setting of the guidance parameter
group.
Display of parameter
↓

↓

↓

Press the MODE key to exit the guidance parameter group.
By pressing the MODE key, you can return to the default monitoring mode
(display of output frequency).
If there is anything you do not understand during this operation, press the MODE key several times to start over
from the step of  display.
 or  is affixed respectively to the first or last parameter in each guidance wizard parameter group.

MODE
MODE
MODE
MODE

Toshiba TOSVERT VF-nC3 Specifications

General

Model	VF-nC3
Category	Inverter
Output Frequency Range	0.1 to 400 Hz
Control Method	V/f control, sensorless vector control
Overload Capacity	150% for 60 seconds
Input Frequency	50/60 Hz
Enclosure Rating	IP20
Input Voltage	200-240V AC
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overheat, Short Circuit
Ambient Temperature	-10°C to +50°C
Communication	Modbus RTU
Cooling Method	Fan Cooled
Operating Temperature	-10°C to +50°C
Storage Temperature	-20°C to +60°C
Humidity	5 to 95% RH (non-condensing)
Altitude	Up to 1000m
Braking Unit	Built-in braking transistor (for models up to 22kW), External braking resistor required