Configuring VPN L2TP Configuration
Configuration Guide
135
Account Name Specify the account name of L2TP tunnel. It should be configured identically on
server and client.
Password Specify the password of L2TP tunnel. It should be configured identically on server
and client.
WAN Specify the WAN port used for L2TP tunnel.
Server IP Specify the IP address or domain name of L2TP server.
IPSec
Encryption
Specify whether to enable the encryption for the tunnel. If enabled, the L2TP tunnel
will be encrypted by IPSec (L2TP over IPSec).
Pre-shared Key Specify the Pre-shared Key for IKE authentication.
Remote Subnet Specify the remote network. (It’s always the IP address range of LAN on the remote
peer of the VPN tunnel.) It’s the combination of IP address and subnet mask.
Upstream
Bandwidth
Specify the uptream limited rate in Kbps for L2TP tunnel.
Downstream
Bandwidth
Specify the downstream limited rate in Kbps for L2TP tunnel.
Working Mode Specify the Working Mode as NAT or Routing.
NAT: NAT (Network Address Translation) mode allows the router to translate
source IP address of L2TP packets to its WAN IP when forwarding L2TP packets.
Route: Route mode allows the router to forward L2TP packets via routing protocol.
Status Check the box to enable the L2TP tunnel.
2) Click OK.
To Next Page
Loading...
