Configuration Guide 134
Configuring VPN L2TP Configuration
Follow these steps to configure the L2TP server:
1) Specify the WAN port used for L2TP tunnel.
2) Specify whether to enable the encryption for the tunnel.
IPSec
Encryption
Specify whether to enable the encryption for the tunnel. If enabled, the L2TP
tunnel will be encrypted by IPSec (L2TP over IPSec). If you choose Auto, the L2TP
server will determine whether to encrypt the tunnel according to the client ‘s
encryption settings.
3) Specify the Pre-shared Key for IKE authentication.
4) Enable the L2TP tunnel.
5) Click OK.
3.4 Configuring the L2TP Client
Choose the menu VPN> L2TP > L2TP Client and click Add to load the following page.
Figure 3-4 Configuring the L2TP Client
Follow these steps to configure the L2TP client:
1) Specify the name of the L2TP tunnel and configure other relevant parameters of the
L2TP client according to your actual network environment.
Tunnel Specify the name of L2TP tunnel.
To Next Page
Loading...
