Configuring Transmission Routing Configurations
Configuration Guide
75
Description Enter a brief description for the rule.
Status Check the box to enable the rule.
6.2 Configuring the Policy Routing
Choose the menu Transmission> Routing > Policy Routing and click Add to load the
following page.
Figure 6-2 Configuring the Policy Routing
Specify the name of the policy routing entry and configure other related parameters. Then
click OK.
Service Type Specify the service type for the rule.
Source IP Enter the source IP range for the rule. 0.0.0.0 - 0.0.0.0 means any IP is acceptable.
Destination IP Enter the destination IP range for the rule. 0.0.0.0 - 0.0.0.0 means any IP is acceptable.
WAN Specify the outcoming port for the rule.
Effective Time Specify the effective time for the rule.
Description Enter a brief description for the rule.
Status Check the box to enable the rule.
To Next Page
Loading...
