Configuring Network Switch Configuration
Configuration Guide
33
Enable Port
Mirror
Check the box to enable Port Mirror function.
Mirror Mode Choose the mirror mode which includes Ingress, Egress and Ingress and Egress.
Ingress: The packets received by the mirrored port will be copied to the mirroring
port.
Egress: The packets sent by the mirrored port will be copied to the mirroring port.
Ingress and Egress: Both the incoming and outgoing packets through the
mirrored port will be copied to the mirroring port.
2) In the Monitor List section, set the mirroring port and the mirrored port(s), then click
Save.
Mirroring Port The packets through the mirrored port will be copied to this port.
Usually, the mirroring port is connected to a data diagnose device, which is used
to analyze the mirrored packets for monitoring and troubleshooting the network.
Mirrored Port The packets through this port will be copied to the mirroring port.
Usually, the mirrored ports are the ports to be monitored.
6.3 Configuring Rate Control
Rate Control enables you to control the traffic rate for the specific packets on each port to
manage your network.
Choose the menu Network > Switch > Rate Control to load the following page.
Figure 6-3 Configuring Rate Control
Choose the port and configure the ingress frames or egress frames limitation, then click
Save.
Ingress Limit Check the box to enable the Ingress Limit feature.
To Next Page
Loading...
