Configuration Guide 64
Configuring Transmission NAT Configurations
Note:
One-to-One NAT take effects only when the connection type of WAN is Static IP.
2.3 Configuring the Virtual Servers
Choose the menu Transmission > NAT > Virtual Servers and click Add to load the
following page.
Figure 2-3 Configuring the Virtual Servers
Follow these steps to configure the Virtual Servers:
1) Specify the name of the Virtual Server rule and configure other related parameters.
Interface Specify the effective interface for the rule.
External Port Enter the service port or port range the router provided for accessing external
network. The ports or port ranges cannot overlap with those of other virtual
server rules.
Internal Port Specify the service port or port range of the LAN host as virtual server.
Internal Server
IP
Enter the IP address of the specified internal server for the entry. All the requests
from the internet to the specified LAN port will be redirected to this host.
Protocol Specify the protocol used for the entry.
Status Check the box to enable the rule.
2) Click OK.
To Next Page
Loading...
