Configuring VPN PPTP Configuration
Configuration Guide
139
Note:
•
The starting IP address should not be greater than the ending IP address.
•
The ranges of IP Pools cannot overlap.
4.2 Configuring PPTP Globally
Choose the menu VPN> PPTP > Global Config to load the following page.
Figure 4-2 Configuring PPTP Globally
In the General section, configure PPTP parameters globally and click Save.
PPTP Hello
Interval
Specify the time interval of sending PPTP peer detect packets.
PPP Hello
Interval
Specify the time interval of sending PPP peer detect packets.
NetBIOS
Passthrough
Enable NetBIOS Passthrough function to allow NetBIOS packets to be broadcasted
through VPN tunnel.
4.3 Configuring the PPTP Server
Choose the menu VPN> PPTP > PPTP Server and click Add to load the following page.
Figure 4-3 Configuring the PPTP Server
To Next Page
Loading...
