Trane Technologies Thermo King Advancer A360 - Page 20

20
TK 61753-2-MM-EN
Maintenance Inspection Schedule
NNoottee:: Please refer to your Advancer Operator Manual TK 61738-2-OP for Operator Weekly Checks
The service technician is responsible for assessing the condition
of all parts & components found during any service operation to
be in a condition suitable for further operation up to the next
scheduled service. If parts not considered in suitable condition
they should be replaced.
Inspect/Service These Items INSPECTION
A SERVICE
Every 1500
hours Or
every 12
Months
(whichever
comes first)
B SERVICE
Every 3000
hours Or
every 24
Months
(whichever
comes first)
SERVICE C
SERVICE
Every 9000
hours Or
every 72
Months
(whichever
comes first)
EDAC Labour Standard
Single Temperature Units 0.5 hr 2.0 hrs 6.0 hrs
Microprocessor:
Run Pretrip Test (see “Performing a Pretrip Test”). • • •
Engine and Unit Maintenance Items:
Download ServiceWatch data-logger - Check alarm codes, system operation,
function and take corrective action as required.
• • •
Check for faults and operation of the Blue Box. • • •
Check Advancer Controller software revision - Upgrades not included, add the
job code 05200
• •
Check fuel supply. • • •
Check and adjust engine oil level. •
Change engine oil (hot) and oil filter.
• •
*Check and adjust engine coolant level and protection, maintain protection at
35 C (95 F) (or lower if operating in very low ambients).
• • •
Inspect compressor and water pump belts for condition and tension. Adjust/
replace when necessary.
• •
Replace all belts. •
Replace belt tensioner pulley. •
Replace clutch bearings. Check clutch bushings and pins & inspect shoe wear
when compressor is removed.
•
Check water pump seal for weep age and bearing serviceability.
• • •
Listen for unusual noises, vibrations, etc.
• • •
Visually inspect exhaust system for leakage and abnormal smoke or particulate
emissions.
• •
Check and adjust engine speeds (high and low speed). Re-calibrate if required.
• • •
Inspect cyclonic air filter element - Dependent on operating conditions, assess
fitness to continue to next service.
•
Replace Air Filter • •
Check air cleaner hose for security and damage.
• • •
Drain water from fuel tank and assess fuel cleanliness where drain plug is
available.
• • •