54 EMTX-SVX01G-EN
Frequently Asked Questions
device. If you have more than one device selected in Step 3, only the network variables that are
commonly compatible are available for binding.
What are the values shown in the network variables list and the byte list?
The values in the network variables list and the byte list are raw data from the controller shown in
hexadecimal format.
When should I turn on the auto-identify option?
You should turn on the Auto-identity option to identify a device. When this option is enabled, press
the service pin on a device to:
• Add a newly installed device to Active Group tree
• Make the device the active device in Rover (thereby identifying the device)
It is helpful to have two people when using Auto-identify. While one of you watches the Rover
window, the other can press the service pin button on a distant device.
Do no enable Auto-identify during discovery, or every device found attempts to display its status
in the workspace, slowing the discovery process.
Where can I get plug-ins for versions of devices that are not on my laptop PC?
All supported device plug-ins are installed when you install Rover. As new device plug-ins become
available, Trane will announce the methods for obtaining and installing them.
Rover is not discovering any devices. How can I check my USB communications?
Anytime you are having trouble communicating with your devices, you can first check to see if your
USB communications adapters are running correctly. See the installation sheet for more
information on checking your communications.
To Next Page
Loading...