Transport and installation
Delivery of the machine
35
Transport and installation
Delivery of the machine
Conveyors up to a length of approx. 3 m are fully assembled at the factory
and are delivered with pre-adjustments. Conveyors with a length exceeding
3 m are generally delivered in several parts The individual parts are marked
with labels at the section points. Supports, suspensions and other attach
-
ment parts are included separately in the delivery.
Unpacking the machine
Carry out the following work steps:
1. Remove all transport packaging
2. Check for possible transport damage.
3. Check that all items listed on the delivery note have been delivered.
The machine has been unpacked and is complete.
Prolonged storage of the machine
When storing the machine for longer than 4 weeks, the conveyor belt must
be loosened in order to prevent damage caused by bulges The procedure for
slackening the belt is described in the section entitled "Repair". If the
machine is transported by sea, seaworthy packaging is required.
Observe the permissible operating conditions described below also for
storage periods.
For questions concerning storage and transport, please contact TRANS-
NORM SYSTEM GmbH.
To Next Page
Loading...
