Operation
Normal operation
50
Operating instructions: Belt conveyor TS 1208
Version 1.6ENG, 10/04/2018
Normal operation
Normal operation includes the daily switch-on and switch-off procedure and
operation by the operating personnel.
Operation of the conveyor via the overall conveyor system is normally
described in the system documentation or in the control system documenta-
tion.
After a machine downtime of more than 4 weeks, the complete maintenance
procedure described in the maintenance schedule must be carried out. After-
wards, proceed as described in the section entitled "Commissioning"
Decommissioning
The decommissioning includes switching off the machine before service,
maintenance and repair work or before downtimes.
Carry out the following work steps:
1. Turn off the master switch for the power supply according to the control
unit documentation.
2. Secure to prevent the machine being switched on again.
3. Switch components driven by compressed air to compressed air-free.
Reduce the integrated pressure accumulator to 0 bar.
4. Cut off the machine from the compressed air supply.
The machine has been taken out of operation.
To Next Page
Loading...
