Operation
Initial commissioning and commissioning after repair
49
Carry out a test run
Risk of injury due to exposed machine parts!
Parts of the body, hair and clothing can become caught and crushed in
rotating machine parts.
Wear close-fitting protective clothing.
Use a hairnet to cover long hair.
Do not reach into the running machine.
Do not access the machine.
Ask a second person to supervise.
Carry out the following work steps:
1. Switch on the machine.
2. Check that the machine is running smoothly.
? Noise development
If excessive noise occurs:
Locate the source and eliminate the fault, see "Fault elimination".
3. Check the conveyor belt for correct tension and adjustment.
? The conveyor belt runs out of line or jumps out of its holders.
The conveyor belt must be readjusted.
See "Tighten and adjust belt" in the section entitled "Repair".
4. Remove all foreign objects from the working area of the machine.
The machine is ready for normal operation.
The machine has been put into operation.
To Next Page
Loading...
