Operation
Initial commissioning and commissioning after repair
48
Operating instructions: Belt conveyor TS 1208
Version 1.6ENG, 10/04/2018
Carry out the elec-
trical installation
Danger of fatal injury caused by electricity!
The machine is operated with 3-phase alternating current.
The electrical installation must be carried out by qualified and authorised
electricians.
Carry out the following work steps:
1. Install all the required cables.
2. Attach all the required plugs to the cable ends.
3. Connect the cables and establish the required connections in compli-
ance with the operating instructions of the motor manufacturer (see
Appendix, section entitle "Electrical installation").
The machine has been connected.
Check the direction
of rotation.
Risk of injury due to exposed machine parts!
Parts of the body, hair and clothing can become caught and crushed in
rotating machine parts.
Wear close-fitting protective clothing.
Use a hairnet to cover long hair.
Do not reach into the running machine.
Do not access the machine.
Ask a second person to supervise.
Carry out the following work steps:
1. Switch on the machine briefly.
2. Check for correct direction of rotation.
3. Switch off the machine.
The direction of rotation has been checked. The machine is running.
To Next Page
Loading...
