Maintenance and care
Cleaning and care
54
Operating instructions: Belt conveyor TS 1208
Version 1.6ENG, 10/04/2018
* in a plant network with the same conveyor type and the same operating
conditions.
For information on how to carry out maintenance and repair work, please
refer to the section entitled "Repair" in these operating instructions.
Cleaning and care
Increased risk of accident due to:
Exposed machine parts when protective devices are removed.
Do not reach into running machine.
Do not access the machine.
Take the machine out of operation during cleaning work that does not
require it to be running.
Secure the machine against being restarted.
Clean the machine regularly and appropriately for the degree of soiling. It
may only be cleaned dry (with a brush, cloth, compressed air, etc.). Make
sure that the machine (and especially the electrical components) are
protected from moisture.
Quarterly Example*:
Bottom conveyor
track covers,
drive stations
Inspection:
Is there any soiling? If so, remove and clean
the covers.
Quarterly Supports with rubber-
metal buffers
Visual inspection:
Rubber-metal buffer damaged?
If so, replace rubber-metal buffer.
Rubber-metal buffer loose?
If so, tighten joining elements.
Operational maintenance schedule (contd.)
Interval Assembly Maintenance / Inspection
Danger of injury from particles that shoot out when working with
compressed air!
Blindness and injuries to the skin are possible.
Wear personal protection equipment
Wear safety goggles
To Next Page
Loading...
