transnorm TS 1208 - Page 53

Maintenance and care
Maintenance schedule
53
Operational maintenance schedule
Interval Assembly Maintenance / Inspection
Weekly Complete machine Visual inspection:
 After work or at change of shift, make sure
all possible load remains are cleared out of
the machine.
 There must not be any foreign objects left
on the conveyor belt or in the drum/roller
areas.
Weekly Protective devices Visual inspection:
 Is all the equipment complete according to
the operating instructions?
 Is all the equipment undamaged and func-
tional?
Weekly Conveyor belt Visual inspection:
 Is the belt dirty? If so, clean belt.
 Is the surface damaged? If so, replace belt.
 Is the belt bulging up? If so, correct belt
tension and adjustment.
Depending
on the indi-
vidual case
Gear motor
Observe the oper-
ating instructions
provided by the
manufacturer.
Gear:
 Are there any oil marks under the gear? If
so, seal off leak and correct the oil level.
 Check mounting and alignment.
 Is there abnormal running noise? Check the
bearings.
Motor:
 Check the cable routing and temperature.
 Is there abnormal running noise? Check the
bearings.
 Check the cooling fins and air intakes.
Monthly Drive pulley Visual inspection:
 Is the drive pulley dirty? If so, clean the
pulley.
 Is the surface damaged? If so, replace the
pulley.
Monthly Flange bearings and
pedestal bearings
Inspection:
 Can abnormal running noise be heard from
the bearings? If so, replace the bearings.
 Compare bearing temperatures. If one of
them has a significantly higher temperature,
replace the bearing.
Every 6
months
Joining elements Check that bolts subject to dynamic load are
tight.