Repair
Tensioning / adjusting the belt
76
Operating instructions: Belt conveyor TS 1208
Version 1.6ENG, 10/04/2018
Adjusting the belt
Risk of injury due to exposed machine parts!
Parts of the body, hair and clothing can become caught and crushed in
rotating machine parts.
Wear close-fitting protective clothing.
Use a hairnet to cover long hair.
Carry out the following work steps:
1. Loosen the tensioning bolts (4).
2. Evenly tension the belt by turning the tensioning bolts (4) on both sides.
The belt will have a delayed response to the adjustment. Therefore, only
adjust the tensioning bolts slightly. Wait until the belt completes several
rotations before adjusting again.
3. Switch on the machine.
4. Check that the belt runs correctly.
5. Switch off the machine.
6. Repeat steps 2 to 5 until the belt runs correctly.
7. Tighten all the joining elements (3).
The belt has been tensioned and adjusted.
To Next Page
Loading...
