TRENDnet TEW-718BRM User Manual

© Copyright 2013 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-718BRM
28
For additional TEW-718BRM / TEW-718BRM5 routers, make sure to disable the DHCP
server first on all additional routers and configure the LAN IP address to be different on
each router (e.g 192.168.10.2, 192.168.10.3, 192.168.10.4, etc.). You will connect
devices to the LAN ports 1-4 only on all additional routers and the WAN port is not used.
Then, repeat steps 3-9 for additional TEW-718BRM / TEW-718BRM5 routers you are
bridging.
Lazy Mode – Lazy mode is additional WDS configuration option that helps to simplify
setup on to add additional WDS supported devices. At least one device must be
manually configured with all WDS and remote wireless MAC address. The secondary
WDS device must configure at least the wireless channel and wireless security settings.
Then WDS Lazy Mode can be enabled to learn the wireless MAC address of the manually
configured WDS device automatically and create the wireless bridge.
You can repeat the steps to configure the first modem router and configure the wireless
channel, wireless security, and enable lazy mode for enable additional wireless access
points or routers that create a bridge to the first modem router.

TRENDnet TEW-718BRM Specifications

General

Ethernet LAN	Yes
Cabling technology	10/100Base-T(X)
Networking standards	IEEE 802.11b, IEEE 802.11g, IEEE 802.11n, IEEE 802.1p, IEEE 802.1Q, IEEE 802.3, IEEE 802.3u
Ethernet LAN data rates	10, 100 Mbit/s
Ethernet LAN interface type	Fast Ethernet
Modulation	16-QAM, 64-QAM, BPSK, CCK, DBPSK, DQPSK, OFDM, QPSK
Wi-Fi standards	802.11b, 802.11g, Wi-Fi 4 (802.11n)
Channels quantity	13 channels
Top Wi-Fi standard	Wi-Fi 4 (802.11n)
WLAN data transfer rate (max)	150 Mbit/s
Rack mounting	No
Frequency band	2.4 GHz
Frequency range	2.4 - 2.4835 GHz
WLAN data transfer rates supported	11, 54, 150 Mbit/s
Ethernet LAN (RJ-45) ports	4
DSL specification	G.992.1, G.992.2, G.992.3, G.992.5
DHCP client	-
Routing protocols	IGRP, IP, RIP-1, RIP-2
Security algorithms	128-bit WEP, 64-bit WEP, WPA, WPA-PSK, WPA2-PSK
Antennas quantity	1
Certification	CE, FCC
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz
Power consumption (typical)	5 W
Storage temperature (T-T)	-10 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Product color	Black
LED indicators	DSL, LAN, WLAN

Weight and Dimensions

Depth	189 mm
Width	118 mm
Height	33 mm
Weight	221 g