46 Juno Series Handhelds User Guide
4. To transfer files between the computer and the handheld, click Explore. A
Windows Explorer-type window appears, displaying files stored on the
handheld. Copy and paste files to other locations on the computer, or from the
computer to the handheld.
5. To install software onto the handheld, see Installing software onto the handheld,
page 46.
6. To uninstall software from the handheld, select A
dd/Remove Programs from the
Tools menu. Clear the check box beside the program you want to remove and
then click
OK.
For more information, refer to the Act
iveSync Help.
B
Tip – If the GPS Pathfinder Office software is installed on the office computer, you can
configure the Connection Manager utility in the GPS Pathfinder Office software to
automatically detect when you connect a Juno series handheld to the computer. This
enables you to automatically transfer data from the TerraSync software, differentially
correct the data, and then export it to a GIS. For more information, refer to the GPS
Pathfinder Office Software Help.
Installing software onto the handheld
Before you begin, refer to the installation instructions provided with the software.
Some software installations are specifically designed to run on a Windows Embedded
H
andheld. To install software on a Windows Embedded Handheld:
1. Connect the handheld to a computer (see page 44).
2. Copy the installation files to a folder on the handheld.
3. Browse to the folder on the handheld. Tap and hold the installation setup file
and t
hen select Run.
4. If prompted after installation, perform a soft reset of the handheld (see page 22).
To install software that is provided on a CD, or a
s an installation setup that runs on an
office computer:
1. Connect the handheld to a computer (see page 44).
2. If the software is provided on a CD, insert the software CD into the office
co
mputer.
3. Run the installation setup.
4. If prompted, select the install option for a Windows embedded handheld. Once
t
he software is installed on the computer, it is automatically transferred to the
handheld.
Note – I
f a memory card is inserted in the handheld, the card appears as an installation
location option. Trimble recommends that you install software to the handheld’s storage
memory, not to a memory card. If you install software to a card and then remove the card
from the handheld, the software will not be available for use.
5. If prompted after installation, perform a soft reset of the handheld (see page 22).
To Next Page
Loading...