Juno Series Handhelds User Guide 53
Connecting to a Wi-Fi access point
To connect to a Wi-Fi access point, you must:
1. Set up the Wi-Fi connection
2. Connect to the Wi-Fi network or access point.
Note – I
f you have installed a personal certificate on the handheld, you do not need to set
up the wireless connection manually as described in Step 1. To connect to the network or
access point go to Step 2: Connecting to the network or access point.
Step 1: Setting up the Wi-Fi connection
1. Make sure that the Juno series handheld’s Wi-Fi radio is enabled (see page 48).
2. Tap / Settings / Connections / Wireless Manager.
3. Tap
Menu and then select Wi-Fi Settings.
Any networks that you have already configured
ar
e displayed in the list of preferred networks.
4. To add a new network, tap Ad
d New. To change
the settings for an existing network, tap the
network.
5. Enter the name of the network and other
c
onnection details and then tap
Next.
6. Do one of the following
– To use authentication, select the
authentication method from the
Authentication list.
– To use data encryption, select an encryption method from the Data
Encryption list.
– To automatically use a network key, select the check box for The key is
automatically provided. Otherwise, enter the Network key and the Key index.
7. Tap
Next.
8. For increased security, select the U
se IEEE 802.1x network access control check
box and then configure additional authentication information.
9. Tap
Finish.
Step 2: Connecting to the network or access point
1. Disconnect the USB data cable, as the handheld prioritizes a USB connection
over a Wi-Fi connection.
2. Bring the handheld within range of the network or access point.
When a Wi-Fi connection is detected, the access point icon
appears on the
title bar, and a notification message appears on the left softkey.
To Next Page
Loading...