48 Juno Series Handhelds User Guide
Use the Radio Activation Manager software to deactivate the integrated Wi-Fi and/or
Bluetooth radio, or to reactivate the radios if they have been deactivated. The Radio
Activation Manager software runs on an office computer.
The latest copy of the software is available for download from the Trimble website. Go
to www.trimble.com/support.shtml, click the link for your receiver type (Ju
no 3B, or
Juno 3D), click Do
wnloads, click Juno series and then click Radio Activation Manager.
Turning on and turning off the integrated radios
You can use the Wireless Manager application to turn on and turn off the Juno series
handheld’s Wi-Fi or Bluetooth radios, or the Juno 3D handheld’s cellular modem (see
Using the Wireless Manager, below).
You can also turn on or turn off the Bluetooth radio from within the Bluetooth
ap
plication (see Turning on and turning off the Bluetooth radio from within the
Bluetooth application, page 50).
To make the Juno series handheld visible to other Bluetooth-enabled devices and
enabl
e them to connect, see page 51.
Using the Wireless Manager
You can use the Wireless Manager application to turn on and turn off the Juno series
hand
held’s Wi-Fi radio and/or Bluetooth radio, and the Juno 3D handheld’s cellular
modem. You can turn on and turn off any of the radios at the same time, or control
each individually.
To open the Wireless Manager, do one of the following:
• Tap the title bar, tap any of the radio icons and then tap Wireless Manager.
• Tap / Settings / Connections / Wireless Manager.
Turn on the Wi-Fi radio and/or Bluetooth radio to be able to connect to other devices
or n
etworks.
Turn on the Juno 3D handheld’s phone functionality to be able to send and receive text
m
essages, and make and receive voice calls.
Turn off the Wi-Fi radio, Bluetooth radio, and/or phone (Juno 3D handheld only) to
pr
event the handheld from sending or receiving wireless signals.
B
Tip – To conserve power, turn off the radios when not in use.
To Next Page
Loading...