62 Juno Series Handhelds User Guide
10. Unless the phone provider confirmed that you must enter user name, password,
and domain settings to access the Internet, tap
Finish without entering any
information in this screen.
Otherwise:
a. Enter the required information.
b. If the phone provider has told you that you need to change the baud rate or
ot
her settings for the connection, tap
Advanced, configure these settings
and then tap
OK.
c. Tap
Finish.
You are returned to the Co
nnections screen.
You have now configured the dialup networking connection.
Step 2: Connecting to the Internet using the dialup network
1. On the handheld, go to the Connections screen, if it is not already open (tap /
Settings / Co
nnections / Connections).
2. Below My
ISP, tap Manage existing connections.
3. Tap and hold the connection you want to use and then select Co
nnect.
4. Unless the phone provider confirmed that you must enter user name, password,
and domain set
tings to access the Internet, tap
OK without entering any
information in this screen. Otherwise, enter the required information and then
tap
OK.
5. If the phone prompts for confirmation to c
onnect to the Internet, accept the
connection.
The phone dials the configured GPRS access number and then connects to the
In
ternet.
A Connectivity notification appears on the handheld as the connection is being
made.
After the connection is made you are returned to the My
ISP screen.
To confirm that the Juno series handheld is connected to the phone, or to check
t
he status of the connection at any time, tap the title bar and then tap the
Connectivity icon on the pull-down list. The notification shows the name of the
current connection, and the time elapsed since the connection was made. To
hide the notification, tap
Hide.
Note – If
you have an active Wi-Fi connection, the connectivity icon appears as
instead.
6. Tap
OK to close the My ISP screen.
7. Tap
OK to close the Connections / Tasks screen.
8. Tap to close the Co
nnections screen.
To Next Page
Loading...