Safety
2 Safety
TO AVOID POSSIBLE HARM READ AND FOLLOW THESE INSTRUCTIONS.
The machine is built at the time of it's development and production according to applicable, established
technical rules and is considered to be safe to operate.
Dangers can be caused by the machine if the machine:
■
is operated by unqualified personnel,
■
the personnel have not been trained,
■
the machine is used improperly or not as intended,
■
or if the machine is used for other intended purposes.
This chapter provides an overview of all important safety aspects that are necessary for optimum protection
of persons and safe and trouble-free operation of the machine. Other chapters of this manual contain specific
safety notes for the avoidance and prevention of hazards.
2.1 Safety principles
2.1.1 Intended use
The machine described in this manual is intended exclusively for laser engraving and laser cutting,
of material according to the intended use of the machine using the supplied software.
For material details see chapter "Materials" or contact your local Trotec representative, or your local
Technical Support.
The system must be operated, maintained and repaired only by trained personnel familiar with the
designated field of use and the dangers of the machine.
Operate the machine only in technically flawless condition and when it fully complies with the EC Machinery
Directive.
The intended use of this machine also includes that all personnel involved in installation, set-up, operation
maintenance and repair of the machine must have read and understood the Manual and in particular the
"Safety" section, and comply with the instructions.
Organisational measures:
■
Personal protective equipment
■
Inspection of the laser protection wall
■
Laser safety instructions/laser safety training
■
Monitoring by Laser Safety Officer
ENGLISH (Translation) 13
To Next Page
Loading...
Need help?
General
