Safety
2.1.2 Improper use
Use of the machine for any purposes other than those intended or described in the present manual is
regarded as improper and therefore prohibited. Trotec Laser GmbH will not accept any liability for damage
caused by improper use. The risks in case of improper use are exclusively borne by the user.
Non-observance of the operation, maintenance and service instructions described within this manual
absolves Trotec from any liability in case of a defect.
2.1.3 Machine modification
It is strictly prohibited to alter, refit or modify the machine in any way without the express consent of the
manufacturer.
Likewise, it is strictly prohibited to remove, bridge or bypass any safety devices. Operating conditions and
connection and setup values stated in the data sheet must be complied with at all times.
Operation of the system is permitted only with original parts and accessories by the manufacturer. Use of
third-party parts affects machine safety.
2.1.4 Operating modes
Normal operation
For normal operation the following conditions must be met:
•
Intended use of the machine (see chapter "Intended use").
•
Operation of the machine only by trained personnel.
•
Full functional and mounted safety devices.
•
Machine must be in technically flawless condition.
•
Only non-metal and material according to the intended use of the machine must be used.
Warning
In normal operation, the Z-axis position may only be operated in focus.
– The distance in Z between the laser deflector shield and the material surface must not
exceed 3 mm.
Otherwise there is a risk of reflected or vagabonding radiation escaping beyond the laser
deflector shield.
14 ENGLISH (Translation)
To Next Page
Loading...
Need help?
General
