Operation
7 Operation
7.1 Before commissioning
Warning
Personal injury or damage to property due to improper operation.
Improper operation can lead to serious personal injury or damage to property.
– Work on the laser machine may only be carried out by authorized and instructed personnel
familiar with the operation of the machine, observing all safety regulations.
Caution
Risk of injury from laser beam in the room during assembly work.
During assembly work in the laser area, uninvolved third parties (e.g. employees of external
companies) may be injured by laser radiation.
– Shield the machine for the time of installation with laser protection walls (e.g. plywood
panels or PC walls which can withstand the maximum laser power of the system) or with
suitable shields for laser workstations.
– Keep uninvolved third parties away from the laser area.
Check the following points before commissioning:
•
Completeness and technically flawless condition of the machine and safety devices.
•
Order and cleanliness at the workplace.
•
Sensors and protective covers (especially laser shield) for optical damage such as discoloration,
scratches, ....cleanliness of optical components (free of dust and dirt).
•
Cleanliness of optical components (free of dust and dirt).
•
Activated exhaust system.
•
Complete electrical installation.
•
Correct input voltage of the electrical installation.
•
Environmental conditions according to technical specification.
•
Compliance with all laser safety regulations and measures.
•
Fulfill and compliance with all laser safety requirements.
If errors or functional deviations should occur during the inspection of the listed points, the machine is not
considered to be safe to operate and must not (no longer) be put into operation until the cause has been
clarified!
If you have any questions, contact our experienced Technical Support in your local area.
58 ENGLISH (Translation)
To Next Page
Loading...
Need help?
General
