Safety
2.8 In case of emergency
In case of malfunction
■
In case of unusual operating states, open the acrylic top lid to stop working process or respectively press
the Emergency stop button, if available and switch off the laser device.
■
When appropriate disconnect the machine from the mains.
■
Inform laser safety officer and supervisor.
■
Follow the Operating manual.
■
Have repair work performed by Trotec Laser GmbH service technicians only.
■
In case of fire: Use only CO
2
fire extinguisher to quench the fire, insofar as this is possible without
endangering yourself.
Notice
After a deletion, Trotec Technical Support must be involved before the system is put back into
operation.
In case of accident, First Aid
■
If due to laser irradiation eye injury has occurred (upon exceedance of the maximum allowable irradiation
rate), the accident victim must immediately be presented to an ophthalmologist.
■
Assumption of eye injury is justified whenever laser irradiation has occurred and the maximum allowable
irradiation rate may have been exceeded.
■
First aider must pay attention to self-protection.
■
Power off the device.
■
Remove injured person from the danger zone and provide First Aid.
■
Call emergency doctor!
2.9 Secondary (indirect) hazards
2.9.1 Fire hazard
Warning
Fire hazard
Fire hazard from gas and processing of inflammable materials.
– Do not operate the device without supervision.
– Keep CO
2
fire extinguisher ready at hand in the immediate vicinity of the device.
ENGLISH (Translation) 37
To Next Page
Loading...
Need help?
General
