Trotec SP3000 User Manual

Technical Data
3 Technical Data
The technical data sheet can be found in the appendix of this manual.
3.1 Exhaust system requirements
Danger
Danger of emission of toxic gases, vapors or dust.
During laser operation, toxic aerosols may be produced.
– The laser system may be operated only with properly installed and operating exhaust
system.
– Check with the material manufacturer for its toxic effect.
Caution
The laser may only be operated with properly installed and operating exhaust system. Damage
to the system, caused by the use of not any exhaust system or improper extraction equipment,
will not be covered by any liability.
The requirements for the exhaust system and recommended Trotec exhaust systems for standard
applications depend on the working table installed in the machine.
Recommended exhaust systems for SP-Serie:
Exhaust system SP500 SP1500 SP2000 SP3000 SP4000
Atmos Duo Plus ✓
Vent Set 300
Vent Set 400 ✓
(without
vacuum table)
Vent Set 500 ✓
Vent Set 1500 ✓
Vent Set 3000 ✓ ✓
Notice
– Connection has to be carried out by our Technical Support.
– Observe instructions for operation and maintenance according to the operating manual of
the exhaust system.
ENGLISH (Translation) 41

Trotec SP3000 Specifications

General

Brand	Trotec
Model	SP3000
Category	Tools
Language	English