Trox Technik FKR-EU - Page 55

7.10 Trim panels (screw-fixed to metal support struc-
ture)
Mortar-based installation into a lightweight partition wall
Fig. 36: Mortar-based installation into a lightweight partition wall
1 FKR-EU
2.1 Mortar
3.2 Lightweight partition wall with metal support
structure, cladding on both sides
3.6 Compartment wall or safety wall with metal sup-
port structure, cladding on both sides
6.5 Mineral wool (depending on wall construction)
6.11 Insulating strip (depending on wall construction)
7.10 Trim panels (screw-fixed to metal support struc-
ture)
7.13 Cladding
7.14 Reinforcing board of the same material as the
wall
9.2 Extension piece or duct
Z Spigot construction 370 mm
Flange construction 342 mm
# optional
Up to EI 60 S
–
EI 30 S
Installation
Lightweight partition walls > Mortar-based installation
Fire damper FKR-EU 55